![]() ![]() You should replace PUBLICIP with your server's public IP address. This will allow the status output to be accessed from (localhost only works on the server itself - replace localhost with your server IP and it will be accessible externally to the IPs you specify in the Allow list, see below). You then need to add in the following lines to set up the location from which the status output can be parsed by the agent: Look in your Apache error_log for details. If you restart Apache after adding this line and get an error, check that mod_status has been installed correctly. On packaged Ubuntu Apache installations you can enable the mod_status module by using the a2enmod command: sudo a2enmod status 2) mod_status configurationĪdding the following line to your nf file will enable the mod_status output. Removing the # will uncomment the line and enable mod_status. This is usually compiled in by default but you may need to uncomment a line in your nf file: #LoadModule status_module modules/mod_status.so You first need to ensure the mod_status module is installed. ![]() If you do not wish to monitor Apache then leave the default value in the /etc/sd-agent/config.cfg file and the agent will ignore it. This article is outdated and will eventually be removed. See v2 agent Apache monitoring It also requires some additional configuration of your Apache server. This metric is only available for paid accounts. The agent can parse the Apache mod_status output to show the current requests per second, idle and busy workers. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |